تسجيل الدخول لسرعة الوصول إلى أفضل الصفقات. انقر هنا إذا لم يكن لديك حساب.

HOW TUBE AND PIPE MILLS WORK عرض

منذ 5 أشهر عقارات للاجار مكة   38 الآراء

-- ﷼

  • img

0.0 نجمه

موقعك: مكة
السعر: -- ﷼

Tube Mill Machine Lines produce pipe and tube by taking a continuous strip of material and continuously roll forms it until the edges of the strip meet together at a weld station. At this point, the welding process melts and fuses the edges of the tube together and the material exits the weld station as welded tube. Basic components include an uncoiler, straightener, shear, forming section, fin pass section, welder, ID and/or OD scarfing, sizing section, cut off and stacker or runout table.Tube formed metals can be used in many different industries, such as gas, water and sewage piping, structural, industrial, and scaffolding piping. Additionally, your Carbon Steel Tube Mill Machine can produce hollow, rectangular, round or square piping.Galvanized Tube Mill Machines produce pipe and tube by taking a continuous strip of material and continuously rollforming until the edges of the strip meet together at a weld station. At this point the welding process melts and fuses the edges of the tube together and the material exits the weld station as welded tube. Basic components include an uncoiler, straightener, shear, forming section, fin pass section, welder, ID and/or OD scarfing, sizing section, cut off and stacker or runout table.
Each pass in the various sections are made up of a upper and lower shaft that contains roller die tooling which forms the steel strip gradually into a round shape or square if it is a form square / weld square type of mill. This gradual shaping process is commonly referred to as the flower arrangement.
ASP can provide you a turn-key solution for all your New, remanufactured and used tube mill needs.



Tube Mill Components operator face a variety of challenges every day in their effort to produce high-quality tubing in a cost-effective and productive way.

This article examines some of the typical problems producers encounter, some common causes of these problems, and some ideas for how to solve these problems.

Lost Mill Time During Operation and Changeovers

Often, excessive downtime during normal operation or tooling/job changeover can be attributed to one or more of the following causes:

1. No written procedures for setup. Every mill should have written procedures for all operators to follow. The machine, tooling, and steel are fixed factors in the mill setup equation; the only variable is the human factor. This is why it is so important to have written procedures in place to control the process. Written procedures also provide a tool for troubleshooting when problems arise.

2. No setup chart. Tweaking the Cold Rolling Mill during setup loses valuable setup time. Operators must work the tooling the way it was designed. This means setting up to the parameters of a setup chart.



 
ملحوظه: يجب ان تكون عضو معنا حتي تستطيع وضع تعليق.